Options and Accessories
TDS 520A, 524A, 540A, & 544A Service Manual
7Ć5
Accessory Probes
The following optional accessory probes are recommended for use with your
digitizing oscilloscope:
H P6101A 1X, 15Ä‚MHz, Passive probe.
H P6156 10X, 3.5 GHz, Passive, low capacitance, (low impedance Z
O
)
probe. Provides 100X, when ordered with Option 25.
H P6009 Passive, high voltage probe, 100X, 1500 VDC + Peak AC.
H P6015A Passive high voltage probe, 1000X, 20 kVDC + Peak AC
(40 kV peak for less than 100 ms).
H P6205 750 MHz probe bandwidth. Active (FET) voltage probe.
H P6204 Active, high speed digital voltage probe. FET. DC to 1 GHz. DC
offset. 50 W input. Use with 1103 TekProbe Power Supply for offset conĆ
trol.
H P6046 Active, differential probe, 1X/10X, DC to 100 MHz, 50 W input.
H A6501 Buffer Amplifier (active fixtured), 1 GHz, 1 MW, 10X.
H P6501 Option 02: Microprobe with TekProbe power cable (active fixĆ
tured), 750 MHz, 1 MW, 10X.
H AM 503S ÄŠ DC/AC Current probe system, AC/DC. Uses A6302 Current
Probe.
H AM 503S Option 03: DC/AC Current probe system, AC/DC. Uses A6303
Current Probe.
H P6021 AC Current probe. 120 Hz to 60 MHz.
H P6022 AC Current probe. 935 kHz to 120 MHz.
H CTĆ1 Current probe Ċ designed for permanent or semiĆpermanent inĆ
circuit installation. 25 kHz to 1 GHz, 50 W input.
H CTĆ2 Current probe Ċ designed for permanent or semiĆpermanent inĆ
circuit installation. 1.2 kHz to 200 MHz, 50 W input.
H CTĆ4 Current Transformer Ċ for use with the AM 503S (A6302) and
P6021. Peak pulse 1 kA. 0.5 Hz to 20 MHz with AM 503S (A6302).
H P6701A OptoĆElectronic Converter, 500 to 950 nm, DC to 850 MHz
1 V/mW.
H P6703A OptoĆElectronic Converter, 1100 to 1700 nm, DC to 1 GHz
1 V/mW.
H P6711 OptoĆElectronic Converter, 500 to 950 nm, DC to 250 MHz
5 V/mW.
H P6713 OptoĆElectronic Converter, 1100 to 1700 nm, DC to 300 MHz.
5 V/mW.
To Next Page
Loading...
Need help?
General
