Tektronix TDS 420A - Page 12

Table of Contents
viii
TDS 420A, TDS 430A & TDS 460A Service Manual
Table 5--4: GPIB Board Configuration1 5--7.......................
Table 6--1: Relative Susceptibility to Static-Discharge Damage 6--3....
Table 6--2: External Inspection Check List 6--5....................
Table 6--3: Internal Inspection Check List 6--6.....................
Table 6--4: Tools Required for Module Removal 6--12................
Table 6--5: Access Instructions for Modules in Figure 6--2 6--15........
Table 6--6: Access Instructions for Modules in Figure 6--3 6--17........
Table 6--7: Access (and Removal) Instructions for Cables
in Figure 6--4 6--20.........................................
Table 6-- 8: Troubleshooting Test Equipment, Fixtures,
and Supplies 6 --77..........................................
Table 6-- 9: Connections for a 9 to 25 Pin Null Modem Cable 6-- 78.....
Table 6--10: Diagnostic Failure Priority Lists 6--83..................
Table 6-- 11: Normal Output Voltage 6 --85..........................
Table 6-- 12: Power Supply Maximum Current 6-- 87.................
Table 6--13: Front Panel Connector Voltages 6--93...................
Table 6--14: Channel and P1 Signal Locations 6--95.................
Table 6--15: A05 Attenuator Board Power 6--96.....................
Table 6--16: A04 Acquisition B oard Power 6--97.....................
Table 6--17: Regulator Voltages 6--99..............................
Table 6--18: J7 Voltages 6--99....................................
Table 6--19: J8 Front Panel Voltages 6--99..........................
Table 7--1: International Power Cords 7--2........................
Table 7--2: Standard Accessories 7--2.............................
Table 7--3: Optional Accessories 7--3.............................
Table 7--4: Compatible Probes 7--3...............................
Table 7--5: Accessory Software 7--5...............................