Removal and Installation Procedures
6-14
TDS 420A, TDS 430A & TDS 460A Service Manual
H Skip to the end of this procedure (step 3) for reinstallation
instructions.
d. If you have located the module to be replaced in Figure 6--4, you are
removing one of the field replaceable cables. Do the following subparts:
H Go to Table 6--7 on page 6--20.
H Find the procedure that includes the name of the cable noted
in step 1.
H Perform the instructions listed in the table for that procedure to
access and remove the cable.
H Follow the instructions listed in the table for the reinstallation of the
cable. Then exit this procedure.
3. Reinstall all modules removed: Read the instructions found at the end of the
procedure that removes the module to be serviced — they guide you in
reinstalling all modules removed. All procedures are found under Procedures
for Module Removal and Installation on page 6--23, which follows this
access procedure.
To Next Page
Loading...
Need help?
General
