TDS 420A, TDS 430A & TDS 460A Service Manual
7-1
Options and Accessories
This chapter describes the various options and accessories that are available for
the TDS 420A, TDS 430A, and TDS 460A Digitizing Oscilloscopes.
Options
The following options are available.
See Option XL.
This option provides a video trigger. It lets you trigger on positive or negative
sync pulses. It also lets you select interlaced field one, interlaced field two, or
both fields noninterlaced. You can define the signal class to be NTSC, PAL,
SECAM, or you can customize the class.
See Option XL.
See Option XL.
With this option, Tektronix ships the digitizing oscilloscope configured for
installation in a 19 inch wide instrument rack.
See Option XL.
With this option, Tektronix ships a front cover and pouch, RS-232 and a
Centronics interface that can be used to obtain hardcopies of the oscilloscope
screen, a 120,000 Point Record Length, and advanced DSP math (the oscillo-
scope can compute and display three advanced math waveforms: integral of a
waveform, differential of a waveform, and an FFT (Fast Fourier T ransform) of a
waveform).
With this option, Tektronix ships a test data report for the oscilloscope.
Option 02: Front Cover
and Pouch (TDS 400A
Only)
Option 05: Video Trigger
Option 13:
RS-232/Centronics
Hardcopy Interface
Option 1M: 120,000 Point
Record Length
Option 1R: Rackmounted
Digitizing Oscilloscope
Option 2F: Advanced DSP
Math
Option XL: Opt ions 02, 13,
1M, and 2F
Option 95: Test Data
Report
To Next Page
Loading...
Need help?
General
