Removal and Installation Procedures
6-54
TDS 420A, TDS 430A & TDS 460A Service Manual
To J5 of the
A09 DSP
Assembly
To J5 of the A03 CPU
Assembly
Figure 6- 21: Battery removal
6. Reinstallation:
a. If the battery retaining clip(s) was removed, do step 5, reversing the
removal instructions to reinstall the each battery clip.
b. Do steps 3 and 4, reversing the removal instructions to reinstall the each
battery.
c. See the following procedures in the order listed to replace modules
removed by the access procedure:
H Front Cover, Rear Cover, Cabinet, Rear EMI Gasket, and Cabinet
Handle and Feet (page 6--27) to reinstall the cabinet and rear cover
H Line Fuse and Line Cord (page 6 --26) to reinstall the line cord,
which completes the oscilloscope reassembly
To Next Page
Loading...
