Removal and Installation Procedures
6-56
TDS 420A, TDS 430A & TDS 460A Service Manual
Air baffle shield
Mounting
Screw (4)
Hex spacer post
Power Factor
Correction module
Do not remove
these screws
P3
Black and red
connector
Flex cable,
two-connector
(line trigger)
Figure 6- 22: Power factor correction module removal, B080000 & up
e. Disconnect P3 connector located on the low voltage power supply board.
f. Disconnect the remaining two conductor (black and red) connector
located on low voltage power supply board.
g. Lift the Power Factor Module assembly up and at the same time
disconnect the two conductor flex cable (line trigger) from the power
supply.
To Next Page
Loading...
