Removal and Installation Procedures
6-58
TDS 420A, TDS 430A & TDS 460A Service Manual
f. Disconnect J4 CRT PWR two conductor flex cable located on the small
low voltage power supply board.
g. Working through the opening created when the fan was removed (Access
Procedure), remove the T-15 TorxR screw at the center of the power
supply board.
h. Using a pair of duck-bill pliers, squeeze to release each of the four flex
locks at the top edge of the low voltage power supply assembly.
i. Once released, tilt the board out away from the flex locks.
j. Lift the low voltage power supply assembly out of the chassis to
complete its removal.
To Next Page
Loading...
