Application Examples
52
TDS1000/2000-Series Digital Oscilloscope User Manual
2. Turn the VOLTS/DIV and VER TICAL POSITION knobs to set
the waveform amplitude to about five divisions.
3. Push the CH 1 MENU button to see the CH1 Menu if it is not
displayed.
4. Push the Vo l ts/Div option button and select Fine.
5. Turn the VOLTS/DIV knob to set the waveform amplitude to
exactly five di visions.
6. Turn the VERTICAL POSITION knob to center the waveform;
position the baseline of the waveform 2.5 divisions below the
center graticule.
7. Push the CURSOR button to see the Cursor Menu.
8. Push the Type option button and select Time.
9. Turn the CURSOR 1 knob to place the cursor at the point where
the waveform crosses the second graticule line below center
screen. This is the 10% level of the waveform.
To Next Page
Loading...
