Command Descriptions
TDS200/1000/2000 Series Oscilloscope Programmer Manual
2−45
ODD
Video signal display that is synced on odd fields.
EVEN
Video signal display that is synced on even fields.
LINE
Video signal display synced on all lines.
LINENum
Video signal display synced on the specified line number.
DCLIne
Query response when the oscilloscope found a DC level.
DEFault
Query response when the oscilloscope could not determine the signal
type.
NONE
Query response when the AUTOSET menu is not displayed. Set is
ignored.
BUSY? (Query Only)
Returns the status of the oscilloscope. This command allows you to
synchronize the operation of the oscilloscope with your application
program. Refer to Synchronization Methods on page 3-10 for more
information.
Status and error
BUSY?
0 means that the oscilloscope is not busy processing any of the
commands listed in Table 2-25 (*OPC) on page 2-121.
1 means that the oscilloscope is busy processing one of the
commands listed in Table 2-25 (*OPC) on page 2-121.
Group
Syntax
Returns
To Next Page
Loading...
Need help?
General
