Tektronix TDS200 Series Programmer's Manual

Command Descriptions
TDS200/1000/2000 Series Oscilloscope Programmer Manual
2−47
CALibrate:INTERNAL
CALibrate:ABOrt (No Query Form)
NOTE. You should only use this command in a qualified service
environment. For more information about the factory calibration
sequence, refer to the sevice manual for your oscilloscope.
Aborts the factory calibration process. When you abort the factory
calibration, the oscilloscope restores the calibration settings to the
previous factory calibration constants stored in non-volatile memory.
Calibration and Diagnostic
CALibrate:ABOrt
CALibrate:ABOrt
stops the in-process factory calibration procedure.
CALibrate:CONTINUE (No Query Form)
NOTE. You should only use this command in a qualified service
environment. For more information about the factory calibration
sequence, refer to the sevice manual for your oscilloscope.
Performs the next step in the factory calibration operation.
Calibration and Diagnostic
Related Commands
Group
Syntax
Examples
Group

Tektronix TDS200 Series Specifications

General

Brand	Tektronix
Model	TDS200 Series
Category	Test Equipment
Language	English