Tektronix TDS6000 Series Service Manual

Table of Contents
vi
TDS7104 & TDS7054 Service Manual
Figure 4--29: Initial test hookup 4--66..............................
Figure 4--30: Measurement of time accuracy for pulse and
glitch triggering 4--67........................................
Figure 4--31: Initial test hookup 4--70..............................
Figure 4--32: Measurement of trigger sensitivity -- 50 MHz
results shown 4--71..........................................
Figure 4--33: Initial test hookup 4--74..............................
Figure 4--34: Measurement of main trigger out limits 4--76............
Figure 4--35: Initial test hookup 4--77..............................
Figure 4--36: Measurement of probe compensator frequency 4--78......
Figure 4-- 37: Subsequent test hookup 4--79.........................
Figure 4--38: Measurement of probe compensator amplitude 4--80......
Figure 4-- 39: Sine wave generator leveling equipment setup 4--81......
Figure 4-- 40: Equipment setup for maximum amplitude 4--83.........
Figure 5--1: Adjustment setup using a separate controller 5--4........
Figure 5--2: Adjustment setup using the oscilloscope as
the controller 5--5..........................................
Figure 5--3: National Instruments GPIB Interface Pr operties
dialog box 5--8.............................................
Figure 6--1: Line fuse and line cord removal 6--10...................
Figure 6--2: Knob removal 6--11..................................
Figure 6--3: Trim removal 6--13...................................
Figure 6--4: Bottom cover removal 6--14............................
Figure 6--5: Cover removal 6--16..................................
Figure 6--6: Cover removal 6--17..................................
Figure 6--7: External modules 6--18................................
Figure 6-- 8: Internal modules 6--19................................
Figure 6--9: Front-panel assembly removal 6--21.....................
Figure 6--10: J1 flex cable connector removal 6--22...................
Figure 6--11: Front panel board and keyboard removal 6--23..........
Figure 6--12: Display removal 6--25................................
Figure 6--13: Touch panel and LCD assembly removal 6--26...........
Figure 6--14: Display adaptor board removal 6--27...................
Figure 6--15: Cable clip removal 6--27..............................
Figure 6--16: Power flex circuit removal 6--29.......................
Figure 6--17: Floppy disk drive removal 6--30.......................
Figure 6--18: Hard disk drive removal 6--32.........................
Figure 6--19: Removing the hard disk drive from the cartridge 6--32....

Tektronix TDS6000 Series Specifications

General

Brand	Tektronix
Model	TDS6000 Series
Category	Test Equipment
Language	English