Adjustment Procedures
TDS7104 & TDS7054 Service Manual
5-7
a. If using a PCMCIA card, do these steps.
Disable the ATI 3D Rage P ro display adapter (the NLX SVGA display
adapter): right click on My Computer , select Properties, select the
Device Manager tab and then the View devices by type button, click the
+ box on Display adapters, click the ATI 3D R age Pro entry, click the
Properties button, and then click Disable in this hardware profile, click
the OK button, and then click the Close button.
Run msconfig: on the msconfig General tab, click the Advanced button,
check EMM Exclude A000 -- FFFF, click the OK button, and then click
the OK button.
Install the GPIB software, reboot, and then install the PCMCIA GPIB
card (the PCM CIA card may not be recognized until you reboot again).
After completing the adjustment procedures, restore these settings to
their previous values.
b. On the oscilloscope, pull down the File menu and then select Minimize
to minimize the oscilloscope application. You should now see the
Windows 98 desktop.
c. In the Start menu, select Settings > Control Panel.
d. In the Control Panel, double click the System icon to display the System
Properties dialog box.
e. In the System Properties dialog box, select the Device Manager tab.
f. Find the National Instruments GPIB Interfaces icon in the list of
devices. Right click the icon and then select Properties to display the
National Instruments GPIB Interface Properties dialog box.
g. Select the Device Templates tab. You should see a dialog box similar to
the one shown in Figure 5--3.
To Next Page
Loading...
Need help?
General
