Product Description
1-2
TDS5000 Series User Manual
H Two or four input channels (each with 8-bit resolution), C hannel 3 signal
output (depending on model), and auxiliary trigger input and output
H Sample, envelope, peak-detect, high-resolution, and average acquisition
modes
H Full programmability, with an extensive GPIB command set and a message-
based interface
H Extensive suite of advanced triggers including edge, logic, pulse, video, and
sequence at up to 1 GHz bandwidth
H Powerful built-in measurement capability, including optional histograms,
automatic measurements, and measurement statistics
H A large 10.4 inch (264.2 mm) color display that supports color grading of
waveform data to show sample density
H An intuitive graphical user interface (UI) with online help
H Internal disk storage
H Wide array of probing solutions
H Optional integrated thermal printer
H Optional touch screen
H Optional CD-RW drive
Product Software
The oscilloscope includes the following software:
H System Software. The product software runs on a specially configured
version of Windows 2000. Windows 2000 is preinstalled and enables you to
install other compatible applications. To reinstall Windows 2000, use the
Operating System Restore CD-ROM, a standard accessory with your
oscilloscope. Do not attempt to substitute any version of Windows that is not
specifically provided by Tektronix for use with your oscilloscope. (Note that
older versions of the instrument may use Windows ME; contact Tektronix
sales support for information about upgrading an older instrument to
Windows 2000.)
H TDS5000 Product Software. This preinstalled software is the oscilloscope
application and runs on Windows 2000. It provides the user interface (UI)
and all other oscilloscope control functions. You can minimize or even
exit/restart the oscilloscope application as your needs dictate. However, it is
recommended that you exit the oscilloscope application only when installing
new software.
To Next Page
Loading...
Need help?
General
