Teldat Router User Manual

• Intrusive
• 3GPP-ACCESSIBILITY-CONTROL PING
Once the UMTS connection has been established, pings are sent every so many seconds,
indicated in the command, to the configured IP address.
If this times out without having received a response from the remote, a second ping is sent and
a response is expected within 10 seconds. If no response is received, two more pings are sent
every 5 seconds. If no response is received, the device disconnects.
The command is:
3gpp-accessibility-control ping <A.B.C.D> <timer>
<A.B.C.D> : IP Address where the pings are sent.
<timer>: Time between pings.
Example:
Dial Profiles config>profile X 3gpp-accessibility-control ping 10.10.1.1 60
Dial Profiles config>
• 3GPP-ACCESSIBILITY-CONTOL TRACE
Identical to the above, but this sends an ICMP trace route.
The command is
3gpp-accessibility-control trace <A.B.C.D> <timer>
<A.B.C.D>: IP address where the traces are sent
<timer>: Time between them.
Ejemplo:
Dial Profiles config>profile X 3gpp-accessibility-control trace 10.10.1.1 60
Dial Profiles config>
• Non-Intrusive
• 3GPP-ACCESSIBILITY-CONTROL TIMER
Independently to the idle-time value configured in the connection profile, disconnection is
carried out when the configured timer value times out.
The command is:
3gpp-accessibility-control timer <value>
<value>: Timer value between 60 and 86399 seconds.
Ejemplo:
Dial Profiles config>profile X 3gpp-accessibility-control timer 60
Dial Profiles config>
• 3GPP-ACCESSIIBILITY-CONTROL TRAFFIC
This consists of monitoring the data flow in both directions at the IP layer, TCP or any.
The mechanism initiates from the fact that when there is outgoing traffic, there will always be
incoming. A counter for sent frames starts (depending on the type). This value resets each
time there are incoming frames, independently of the type.
The command is:
3gpp-accessibility-control traffic <counter> <type>
<counter> : represents the limit for the outgoing packets (sent to the network) for the
type configured without receiving incoming packets. Once this value has been
reached, the link disconnection process activates in order to try a new connection.
<type>: Type of monitored outgoing traffic.
TELDAT ROUTER– UMTS Configuration
II - 7
Doc.DM757-I
Rev.10.60

Teldat Router Specifications

General

Brand	Teldat
Model	Router
Category	Network Router
Language	English