Telecrane F24+ Series User Manual

3
 Make sure that the batteries are in good condition and power for receiver is correctly supplied.
 The installation and maintenance service is allowed only when the receiver power is disconnected to
avoid electrical shock.
 The contents of this manual may be amended by the manufacturer without notice.
 The specification and function of remote is subjected to change without notice by manufacturer.
PRECAUTIONS
 Operating in an industrial facility is relatively dangerous; therefore, operator must have taken the
adequate trainings in using F24+ system.
 Besides obtaining qualification certificate for operating this remote control product, users must also
be both physically and mentally in well conditions, and has sufficient knowledge with safety
precaution.
 Although F24+ transmitters are solid made for certain level of impact and weathering resistance, but
any malicious destruction or improper use might still cause high possibility of potential damage.
 When transmitter battery power is low (Red LED), a STOP signal will be sent to receiver automatically
to turn off receiver. The batteries must be replaced immediately.
 If the severe interference occurred, the operation must be stopped immediately.
 Please remove the batteries when the equipment will not be used for a long time.
 Be sure to know the "Procedures of Emergency" as follows.
PROCEDURES OF EMERGENCY
In case of an Emergency, please follow the procedure below and contact authorized distributor for
service immediately.
 Press "EMS" button
 Turn the key to "OFF" position and remove it.
 Switch off crane main power.
 Contact authorized distributor for inspection.

Telecrane F24+ Series Specifications

General

Brand	Telecrane
Model	F24+ Series
Category	Remote Control
Language	English