Teledyne T200UP - EPA Equivalency; Approvals and Certifications; Safety; Emc

Teledyne API – Ultra Sensitivity Model T200UP NO/NO
2
/NOx Analyzer Addendum to T200
10 07450B DCN6495
PARAMETER SPECIFICATION
Weight, Ext Pump Pack 21 lbs (9.5 kg)
Environmental
4
Installation Category (Over-voltage Category) II, Pollution Degree 2
(1)
As defined by the USEPA
(2)
At constant temperature and voltage
(3)
With adaptive filter, > 20 ppb change
2.1. EPA Equivalency
Teledyne API’s T200UP nitrogen oxides analyzer is designated as an
equivalent method (Number
EQNA-0512-200) for NO2 measurement, as
defined in 40 CFR Part 53, when operated under the following
conditions:
 Range: Any full-scale range between 0-0.05 and 0-1.0 ppm (parts per
million).
 Ambient temperature range of 20 to 30°C.
 Software Settings: Temperature and Pressure compensation ON.
2.2. Approvals and Certifications
The Teledyne API Model T200UP analyzer was tested and certified for
Safety and Electromagnetic Compatibility (EMC). This section presents
the compliance statements for those requirements and directives.
2.2.1. Safety
IEC 61010-1:2001, Safety requirements for electrical equipment
for measurement, control, and laboratory use.
CE: 2006/95/EC, Low-Voltage Directive
North American:
cNEMKO (Canada): CAN/CSA-C22.2 No. 61010-1-04
NEMKO-CCL (US): UL No. 61010-1 (2nd Edition)
2.2.2. EMC
EN 61326-1 (IEC 61326-1), Class A Emissions/Industrial
Immunity
EN 55011 (CISPR 11), Group 1, Class A Emissions
FCC 47 CFR Part 15B, Class A Emissions
CE: 2004/108/EC, Electromagnetic Compatibility Directive
2.2.3. Other Type Certifications
For additional certifications, please contact Technical Support:
Toll-free Phone:
800-324-5190
Phone:
858-657-9800
Fax:
858-657-9816
Email:
sda_techsupport@teledyne.com
Information contained herein is classified as EAR99 under the U.S. Export Administration Regulations. Export, reexport or diversion contrary to U.S. law is prohibited.