- 12 -
/ : Move between channels (left pane) or programmes (right pane).
P + / P - : Shows the programmes of selected channel through the week.
Changing Channels
• You can change channels with the following methods.
• You can press the numeric buttons (0–9) to directly enter the channel number. You can press numeric buttons
consecutively to enter two or more digits.
• Press the P +/ P - buttons to move up or down to the next available channel.
Note: You can press OK button to display the channel list.
Adjusting the Volume
Volume Up / Down
• You can increase or decrease the volume by using V+ / V- buttons.
• The volume level selected will remain set, even when the receiver is turned off and on again, until you change
volume again.
• The audio volume adjustment for the receiver is independent of the volume control on your TV set.
IMPORTANT: You should be careful that both volume controls are kept within reasonable levels so that when
switching on, or when rst turning on your TV set, the sound level is not too high.
Mute
• You can press to mute the sound of your set top box. The sound will be muted once this button is pressed.
• To cancel mute, you can press button again or use the V +/- buttons.
On-Screen Information
• You can press the INFO button to display on-screen information. Details of the station and current programme
will be displayed on the information screen.
• The information screen will then display the current event name, next event name, starting and ending time,
duration bar, programme mode and the channel number and name.
To Next Page
Loading...
Need help?
General
