- 17 -
Manual channel scan
This menu will be acivated by using the “ ”/“ ” buttons in the Installation menu. By pressing the OK button,
Menu items in manual search menu will be as the following:
1. Satellite
2. DiSEqC
3 Frequency.
4. Polarisation
5. Symbol rate
6. Network search
7. Scan Encrypted
• Satellite Name, Polarization values and Network Search requirements are changed by toggling.
• Frequency and Symbol Rate are entered directly using “0, 1, 2…, 9” keys.
• As soon as entering transponder frequency, the signal level and quality will be reected in the signal strength
bars (Signal Level and Signal Quality bars) at the bottom of the menu. Signal Level bar shows the strength of
the satellite signal. Signal Quality bar shows lock quality of the device for entered values.
• If Network Search item selected as YES, after tuning to that transponder, the parameters of other transponders
will be collected from NIT (Network Information Table) and tuning will be performed for other transponders.
• By pressing OK button values are stored and after the search, if a new program is found, it will be added to the
programme list. Found program’s name is shown as ‘Program’.
To Next Page
Loading...
Need help?
General
