EasyManua.ls Logo

Telemic HouseControl - 1.2.4 Moisture Alarm; 1.2.5 Temperature Alarm

Default Icon
25 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Introduction 9
In HouseControl, smoke detectors are always connected to continuous power supply with backup
battery. You do not have to worry about changing batteries to smoke detectors any more.
1.2.4 Moisture Alarm
Protection against water damages is essential to M- and L-model HouseControls. HouseControl closes
the water mains valve automatically when monitoring is switched on or when moisture is detected in
areas that should be dry. HouseControl not only sends a text message and makes an alarm phone call
but also alarms people at home with the local alarm siren and yard lights. Moisture detection is on 24
hours a day.
When moisture alarm goes off, HouseControl does not automatically open the water mains valve
because you should find out the reason for the alarm and repair the possible causes that lead to the
alarm before it is safe to open the valve (see 1.2.11). Moisture alarm also stops air-conditioning.
1.2.5 Temperature Alarm
In addition to its own device temperature, HouseControl monitors room, garage, and outdoor
temperatures depending on how many temperature sensors are installed. Temperature alarm limits can
be set as high or low as you prefer (see 2.7).
If you wish to use temperature alarms with thermostatic control (available in S-model), the alarm limits
must have margins of at least three degrees. For example, if you use thermostatic control to keep the
temperature at 10 to 21 degrees above zero, the alarm limits should be at 7 and 24 degrees respectively
(see 2.7).
1.2.6 Restart Notification
HouseControl sends you a restart notification about half an hour from the moment it was switched on.
The notification is sent every time the unit is switched on.
1.2.7 Scheduled Message
HouseControl sends you, or whoever has his or her phone number in directory memory cell one, a
weekly report about the conditions at your home. Time starts counting from the moment the unit is
switched on. The scheduled message contains temperature values from connected sensors (see 2.6.3).
Home IN10:+ HouseControl started
Home IN16:+ Temperature
alarm T2: +9.4 Indoor 1
Alarm phone call “BEEP - BEEP - BEEP”
Home IN4:+ Moisture alarm
Alarm phone call “BEEP - BEEP - BEEP”

Related product manuals