Teletek electronics ECLIPSE 8 - Page 43

ECLIPSE 8/16/32/99 Series – User Operation Manual
43

71
Manual test

72
No AC mains power supply

73
Mains power supply restore

74
Battery low charge

75
Battery loss

76
Battery restore

77
Siren output short-circuit

78
Siren line broke out

79
Siren restored

80
2-wire fire line fault (PGM1)

81
2-wire fire line fault restored (PGM1)

82
Fuse blown out

83
Fuse restore

84
Telephone line loss

85
Telephone line restore

86
System power up

87
System reset

88
Time change

89
Sending of message is impossible

90
Sending of message is impossible restored /
Report to monitoring station restored

91
Periphery device loss

92
Periphery device restore

93
Tamper from periphery device

94
Tamper from periphery device restore

95
Arming on “no movement” failure

96
User Code Changed

97
Invalid date and time

98
Clearing the log from user

99
Arming without reviewing the current system troubles

100
Low battery charge of wireless device

101
Low battery charge of wireless device Restore

102
Lost battery of wireless device

103
Wireless device Restored

104
Dirty smoke chamber of wireless fire alarm detector

105
Dirty smoke chamber of wireless fire alarm detector Restored

106
Radio frequency jamming of wireless expander

107
Radio frequency jamming of wireless expander Restored

108
Loss of main power supply of device

109
Loss of main power supply of device Restore

110
Problem with battery of wireless device

111
Problem with battery of wireless device Restore

112
Blown up fuse of device

113
Blown up fuse of device Restore

118
Communication with monitoring station failed

133
The number of entered incorrect codes (address 16 in the
Manager’s menus) is reached.

134
Forced arming when there is a trouble with the communication
(PSTN/GPRS/LAN) and the connection of the siren to PGM5
(Eclipse 32/99) is incorrect - no balancing resistor is connected
between PGM5 and +P terminals.

135
Low battery (trouble with the battery) of wireless siren

136
Battery Restore of wireless siren

137
Wireless siren Lost

138
Wireless siren Restore

139
Trouble with tamper switch of wireless siren

140
Tamper switch of wireless siren Restore
(1) – The events are not sent to the monitoring software.