ECLIPSE 8/16/32/99 Series – User Operation Manual
28
5.4 Turning on the Chime signalization by Manager
Attention: This menu is available for ECLIPSE 8 control panel only.
The Chime signalization is a sound signal from the keyboards when opening an entry/exit
type zone. The option can be enabled or disabled by the manager. By default, the Chime
signalization is ENABLED.
In text menus to enable the Chime go to menu “4. SETTINGS – 4. Chime”.
In address menus follow the sequence:
See item 4.3 for the visualization according the used keyboard.
5.5 Zones bypassing by Manager
Bypassing zones is done in manages menu “2. ZONE BYPASS” (Address 04) or by
pushing the BYPASS button, after a valid user code has been entered:
Note: Bypassing zones with LED 8 and LED 16A keyboards is possible only by entering
address 04, because these keyboards do not have a BYPASS fast button.
See item 4.4 for the visualization according the used keyboard.
To check the bypassed zones in the system, see item 3.8.
Note: Certain Managers may not be permitted to bypass zones. In order for users to
bypass zones option “BYPASS ENB” must be enabled in manager’s menu 1. USERS –
xx. User – 02. Options (Address 06 – option 3).
5.6 Engineer Access
In this menu the manager can enable/disable the engineer access (access to the engineer
programming menus). In text menus set the Engineer Access go to menu “4. SETTINGS -
3. ENGINEER ACCESS”.
In address menus follow the sequence:
By default, engineer access is ENABLED.
2. ZONE BYPASS
To Next Page
Loading...
