INSTRUMENT MANUAL
VACUUM GAUGE MODEL MM200
160Phone:(215) 947-2500 fax:(215) 947-7464 e-mail:sales@televac.com web site:www.televac.com
MM-200_im REV M
Page 121 of 160
6. Unmark stations.
This command "Ux<cr>", removes stations from automatically having their data outputted.
All marked stations should be unmarked with this command prior to using the "Rx<cr>"
command (above). The response to this command is an "A" followed by a "<cr>".
7. Read set-point assignments.
This command is "SPx<cr>", where "x" is the set-point whose assignment is desired to be
known. The response is simply the station number followed by a "<cr>".
8. Change a set-point assignment.
This command is "SAxSy<cr>", where "x" is the PCR number, and "y" is the station to
which it is to be assigned. The response to this command is an "A" followed by a "<cr>".
9. Disable the ability of a local operator to operate the SETUP pushbutton, the TEST
pushbutton, the GAS pushbutton or units selection from the front panel. This command is
used when total automatic control is desired with no interference in RS232 operation
caused by operation of front panel pushbuttons.
This command is "FA<cr>". The response is an "A" followed by a "<cr>".
10. Disable the ability of a local operator to change
setpoint assignments, setpoint settings or to change the Gas/No-Gas assignments or units
selection from the front panel. This has the same effect as the LOCK/SETUP switch on
the back panel of the RS232 module.
This command is "FI<cr>". The response is an "A" followed by a "<cr>".
11. Enable a local operator to make the changes inhibited
by the previous command. Except that the local operator will not be able to make these
changes if the rear panel inhibit switch is activated.
This command is "FE<cr>". The response is an "A: followed by a "<cr>".
To Next Page
Loading...