Televic Confidea G3 - 3 Configure Network Settings; Change IP Settings

USER GUIDE – Confidea G3 16
3. Configure network settings
3.1. Change IP settings
1. Click the Menu button and click the Network menu item. You can configure the following
settings:
Parameter
Description
Hostname
Change the hostname of the WCAP.
Address mode
Choose between static and DHCP mode:
• Static: in this mode the IP address and
subnet mask are fixed and must be
inserted into the appropriate fields.
• DHCP: DHCP (Dynamic Host
Configuration Protocol) is a protocol
used by the WCAP to automatically
obtain the parameters necessary for
operation in an IP network. This
reduces system administration
workload, allowing the WCAP to be
added to the network with little or no
manual configuration.
There must be a DHCP server on the
network that dynamically assigns IP
addresses when using the DHCP setting.
IP address
Enter the fixed IP address of the WCAP. (Only
available in static mode).
Subnet mask
Define the subnet of the WCAP
Gateway
Is the access point to another network.
API TCP port
2. Click Save settings.