USER GUIDE ā Confidea G3 9
INSTALLING THE CONFIDEA WCAP
1. Plug in the 24V adapter to the device and the power socket.
2. Connect the LAN cable to your computer or the LAN network that contains your computer.
3. Switch on the Confidea G3. The left LED light will start blinking white, this means the system
is booting.
4. When the LED light turns green, the device is active.
Note: when the light does not turn green or turns red, please contact your local support team.
1.3.3. Access the Confidea G3 web server
CONFIGURING YOUR IP ADDRESS
Before you can access the web server, make sure that your computer has an IP address and
subnet mask that can access the IP address of the WCAP. The default IP address of the WCAP is
192.168.1.110 so the computer should have an IP address that is within the same subnet, like
192.168.1.11 and 192.168.1.20. The subnet mask must be the same for all equipment on the
network, being 255.255.255.0). Follow the procedure described below to configure your IP
address and access the WCAP
1. Go to Control panel.
2. Click Network and Internet and then Network and sharing center.
To Next Page
Loading...
