Televic Confidea G3 - 5 Configure Conference Settings; Initialization; Initialize Units through Open Access; Manually Initialize Units

USER GUIDE – Confidea G3 19
5. Configure conference settings
5.1. Initialization
In stand-alone mode, the WCAP supports two kinds of initialization:
• Open access: any unit can connect to the WCAP without an initialization procedure.
• Manual initialization: a unit can only connect after it completes a certain procedure.
5.1.1. Initialize units through open access
1. Click the Menu icon and select Initialization.
2. On the Initialization page select Open access. With this option the WCAP will detect all active
units (activate by pressing the microphone button) and add them to initialization list. Once a
unit is added its LED lights will turn off.
3. To edit the name and add groups select Manual initialization and click Edit configuration.
For more information see Edit units
.
4. Click Clear initialization to remove the current setup.
5. Click Confirm to accept.
5.1.2. Manually initialize units
1. Click the Menu icon and select Initialization.
2. On the Initialization page select Manual initialization. To be able to detect the units, it must
be active (press the microphone button on the unit). If the unit did not detect the WCAP, its
LED lights will blink green. When it detects the WCAP the LED light will blink red.
3. If there are already units present in the Initialization list click Clear initialization to remove
the current setup.
4. Click Open initialization. When you start the new initialization, the microphone status LED’s
on all wireless units will start to blink red .
Microphone LEDs blinking red at a rate of 2 Hz is an indication that the units are trying to
connect to the WCAP.
Microphone LEDs blinking red at a rate of 1 Hz is an indication that the units are waiting for
the initialization.