TELINDUS 1132/1133 Web Interface User’s Guide
Version 2.0 Page 24/57 December 2004
4.5.3 Firewall/NAT Services
You can enable or disable Firewall and NAT by clicking on SETUP and under LAN Setup, select
Firewall/NAT Services. By unselecting the “Enable Firewall and NAT Services” button the firewall
and NAT services is disabled for all WAN connections (Figure 14)
Figure 14 (Firewall/NAT Services)
The Apply button will temporarily save these settings. To make the change permanent, you need
to click on Save All Settings. At the System Commands page under the TOOLS, click on Save
All.
To Next Page
Loading...