Telit Wireless Solutions LE910C series - Module Setup and Installation Guide; Setup Prerequisites; Installing WHQL Drivers

LE910Cx-WE866Cx LTE Bundling User Guide
1VV0301578 Rev. 9 Page 21 of 56 2020-05-26
5. SET UP
5.1. Prerequisites
5.1.1. Hardware Requirements
• Telit Evaluation Board
• Multi Technology Interface Board
• M.2 Card
• One USB3.0 Micro-B port cable
• One 12V 1.25 Amps Power Adapter
• A SIM card with data connectivity.
5.1.2. Software Requirements
• WHQL Drivers
• A serial terminal such as TATC (Telit AT Controller) to communicate over the
COM interface.
5.2. Installing WHQL Drivers
1. Go to URL: https://www.telit.com/evkevb-drivers/ and download the Windows
Hardware Quality Labs (WHQL) drivers as shown below.
Figure 5-1 Downloading Telit WHQL Drivers
2. Unzip the “Windows10WHQLDriversInstaller_2.09.0002.zip” file and extract the
windows installer package depending on your host system architecture:
• x86: Telit WHQL Drivers x86
• x64: Telit WHQL Drivers x64
Figure 5-2 WHQL Driver Package