TL113046
Installation Manual Ford F650 TELMA AF50-90 SPL100 relay box 124 UIM
Page 3 of 18_____________________________________________________________________________15sep21jh
SCOPE OF THIS MANUAL
This manual covers the installation of Telma into the Ford F650 chassis equipped with
Spicer SPL100 driveline. This manual and the kit listed is not compatible with driveline
u-joint sizes larger than SPL100. Contact Telma engineering support at
engineering@telmacse.com for additional information or help with a Telma installation
on a chassis equipped with larger u-joint sizes.
Due to the variations of the Ford F650 chassis which can have many different options
which affect the driveline such as engine choice, air or hydraulic brakes, and air or
spring suspension, it is necessary to submit an installation drawing request using our
Online Installation Drawing Request Form. TIL03019 Chassis Measurement Templates
and TIL03020 Driveline Retarder Pre-Installation Measurement Guide can be used as
worksheets to gather the necessary information. Contact Telma engineering support at
engineering@telmacse.com if you have any questions.
SECTION 1 PREPARATION OF THE CHASSIS
1.1 DRIVELINE
Remove the complete drive-shaft assembly after measurements have been taken.
1.2 EXHAUST
Remove the exhaust just past the DPF sensors.
To Next Page
Loading...
