Teltonika FMB002 Manual

https://wiki.teltonika-gps.com/view/FMB002_First_Start
FMB002 First Start
Main Page > OBD Trackers > FMB002 > FMB002 First Start
Advanced Plug and Track real-time tracking terminal with GNSS, GSM and Bluetooth
connectivity
Contents
1 How to insert Nano-SIM card and connect battery
2 Pinout
2.1 PC Connection (Windows)
2.2 How to install USB drivers (Windows)
2.3 Configuration (Windows)
2.4 Quick SMS configuration
3 Safety information
3.1 Precautions
How to insert Nano-SIM card and connect battery
Open the top cover of the device. The cover is opened by unclipping it at the recessed corner.1.
Insert Nano-SIM card as shown with PIN request disabled' or read our Wiki how to enter it2.
later in Teltonika Configurator. Make sure that the Nano-SIM card is fitted properly into the
holder.
Connect the battery as shown in the figure.3.
After configuration, see “PC Connection (Windows)”, attach device cover back.4.
The device is ready to be mounted.
Nano-SIM card insertion/removal must be performed when device is powered off –
external voltage and battery are disconnected. Otherwise Nano-SIM card might be
damaged or device will not detect it.

Teltonika FMB002 Specifications

General

Tracking sensitivity	-165 dBm
Hot start	1s
2G bands	850/900/1800/1900 MHz
Data transfer	GPRS
Bluetooth	No
Internal High Gain GNSS antenna	Yes
Internal High Gain GSM antenna	Yes
SMS	Yes
GPRS	Yes
Crash detection	Yes
Over Speeding detection	Yes
Cellular Connectivity	2G
Input Voltage	10-30V DC
Digital Outputs	1
Analog Inputs	1
CAN	No
Accelerometer	Yes
Internal Antenna	Yes
External Antenna Connector	Yes
GNSS	GPS, GLONASS
Position Accuracy	2.5 m
Technology	GSM/GPRS
Operating temperature	-40°C to +85°C
Time Synchronization	Yes
Fuel monitoring	Yes
SIM Card Slot	Yes
Firmware Updates	Yes
Protocols	TCP, UDP
Data Storage	Yes
Warm start	25 s
Cold start	35 s