CALIBRATION / ADJUSTMENT
6.Calibration/Adjustments
• Spikes will be calibrated with the paddle thermocouples (Automatic profiling) (for
more information, see the DTC-Technical Manual).
• Change only the PID-adjustments if the furnace temperature isn't stable (for more
information, see the DTC-Technical Manual).
• Adjustment of the Excess Temperature controller, adjustment of the setpoint to the
process temperature (for more information, see item Error! Reference source not
found.).
• In case of an Digitric 500 Overtemperature Security, instead of an Excess
Temperature controller look in paragraph Error! Reference source not found..
FURNACE REFERENCE MANUAL
6-1
To Next Page
Loading...