Tenda D301-V2 - Diagnostic Tools

Wireless Modem Router
40
When the PPPoE connection is successful, you can access Internet.
IP over Ethernet (IPoE)
If your ISP uses DHCP to assign your IP address or if your ISP assigns you a static (fixed) IP address, IP subnet mask
and the gateway IP address, you need to select the IP over Ethernet (IPoE).
Click Advanced Setup -> WAN Service -> Add, select the configured interface and then click Next to enter the
following screen.
Select IPoE.
Edit the Enter Service Description. This field is optional. We recommend that you keep the default.
Select a network protocol: IPv4, IPv6 or IPv4 & IPv6 (dual stack).
Click Next.
_________________________________________________________________________________________________
Note:
If you select IPv6 or IPv4 & IPv6 (dual stack), skip to IPv6.
_________________________________________________________________________________________________