114
WPS Setup
Wi-Fi Protected Setup makes it easy for home users who know little of wireless security to establish a home network, as
well as to add new devices to an existing network without entering long passphrases or configuring complicated settings.
Enable WPS: This is WPS ON/OFF turn. Click it to enable or disable WPS. WPS is disabled by default.
Device PIN: This is PIN code of the modem router for WPS PIN mode.
Enter SAT PIN: “SAT” means the remote wireless client requiring a connection. Enter its PIN code in the blank if you
select this option, and then click .
Use AP PIN: “AP” means the modem router. Select this option if you copy the PIN code of the modem router to the
remote wireless client.
NOTE
1. WPS/RST button in the device back panel: When WPS feature is enabled, press this button on the device for 1~3
seconds and the WPS LED will keep blinking for about 2 minutes. Within the 2 minutes, press the WPS button on
your wireless clients. When the WPS displays a solid light, the wireless client has joined in your wireless network.
2. To use the WPS security, the wireless client must be also WPS-capable.
3. WPS only supports WPA2, which means only when you select “WPA2” encryption or “Open” you can change WPS
status.
To Next Page
Loading...
