15
Bridge
① Select Auto or DSL link type and select Bridge connection type.
② Configure the PVC, ISP and country settings manually. Click here to check PVC value or consult your ISP if
you cannot locate this info. (Note that Auto PVC scan is not available for Bridge.)
③ Finish the wireless setup. (Recommended)
④ Click OK.
When Bridge mode in DSL access is enabled, dial up from the local PC with the account provided by your ISP for
Internet service.
________________________________________________________________________________________________
NOTE
If your country and/or your ISP are not covered on the Home page, select “Other” from the country list and configure the
VPI and VCI value manually. If you cannot locate this information, refer to Appendix 5 VPI/VCI List or ask your ISP to
provide it. For more information, see To Set up the ATM interface and To Set up WAN Service for ATM Interface.
_________________________________________________________________________________________________
To Next Page
Loading...
