Tenda D305 - Page 54

49
Step 5: To configure the WAN gateway address. After you configure it click Next. The default setting is recommended.
Step 6: To configure the WAN DNS address. Choose a way to get DNS server according to what your ISP has provided.
-Click the Select DNS Server Interface from available WAN interfaces option.
-Select the Use the following Static DNS IP address option and enter static DNS server IP addresses for the system.
And then click Next.
NOTE
1. In ATM mode, if only a single PVC with IPoA or static IPoE protocol is configured, Static DNS server IP addresses
must be entered.
2. If you cannot locate the static DNS server IP information, ask your ISP to provide it.