68
IP over Ethernet (IPoE)
If you get an IP address from your ISP automatically or if your ISP assigns you a static (fixed) IP address, subnet mask
and gateway, you need to select the IP over Ethernet (IPoE).
IPv4
Step 1: Click Advanced Setup > WAN Service and then click the Add button.
Step 2: Select the ETH interface you added just now from the pull-down menu in the figure below. Click Next.
Step 3: Select IP over Ethernet as WAN service type. Edit the Enter Service Description. This field is optional. It is
recommended that you keep the default. Select a network protocol: IPv4 Only. And then click Next.
To Next Page
Loading...
