Tips:
When the ONT is set to Bridge mode, please configure internet settings based on ISP requirements.
Bridge mode
Access internet over PPPoE
➊ Connect a LAN port of the ONT to the WAN port of the router using an Ethernet cable.
➋ Connect the computer to a LAN port of the router using an Ethernet cable.
➌ Set up a PPPoE connection on the router as required.
After the settings, you can access the internet through the router.
ON/OFF
PON
PWR
USB
WPS
WLAN
TEL LAN4 LAN3 LAN2 LAN1
RESET
Computer
Ethernet cable
1 2
Power source
Ethernet cable
WPSReset
WAN
1
2
IPTV/3
POWER
WAN
LAN
router
Power source
LAN
Internet
ONT
8
To Next Page
Loading...
