IB 340133 (10-02) 1
No. 340133
Machine: ATLV 4300
Published: 10-02
Rev. 07
INSTRUCTION BULLETIN
NOTE: DO NOT DISCARD the Parts List from the Instruction Bulletin. Place the Parts
List in the appropriate place in your machine manual for future reference.
Retaining th e Parts List will make it easier to reorder individu al p arts and will
save you the co st of ordering an entire kit.
NOTE: Numbers in parenthesis ( ) are reference numbers for parts listed in Bill of Materials.
Installation instructions for kit n u mber 367613
DESCRIPTION:
This kit contains the parts needed to install/replace a dust filter kit option on the model ATLV
4300 Litter Vacuum.
Please follow step-by-step instructions.
SPECIAL TOOLS / CONSIDERATIONS: Hand Drill and Following Drill Bits: 13/64 [5.2 mm],
19/64 [7.5 mm], and 11/32 [8.7 mm]
(Estimated time to complete: 3 hours)
PREPARATION:
(Refer to FIG. 1 thru 9)
1. Park machine on a clean level work surface.
FOR SAFETY: Before leaving or servicing machine,
stop on level surface and set parking brake.
Then turn off machine and remove key.
2. Disconnect battery cables from the machine.
W ARNING: Always disconnect battery cables
from machine before working on electrical
components.
3. Remove the filter bag and vacuum fan exhaust
plate from the vacuum fan housing.
WARNING: Spinning fan. Stop engine
before opening debris canister.
4. Open and lower the debris canister . Remove any
garbage bags or liners from the debris canister.
To Next Page
Need help?
General
