Tennant B10 - User Manual

Other manuals for Tennant B10

Service Information Manual88 pages

Questions and Answers

D
Dakota JohnsonJul 30, 2025
Why Tennant Floor Machine has no power?
- B
  Bethany ShepardJul 30, 2025
  Several factors can cause a Tennant Floor Machine to lose power. The emergency stop button may be activated, so turn the button to reset it. The batteries might be discharged, so recharge them. Check for loose or disconnected battery cables and secure them. The circuit breaker may have tripped, so reset the 150 A main circuit breaker. A faulty key switch could also be the cause, or a machine fault has been detected.
R
Ralph CruzAug 3, 2025
What to do if Tennant Floor Machine has short run time?
- C
  Cynthia BurnettAug 3, 2025
  If your Tennant Floor Machine has a short run time, there are several possible reasons. The battery charge may be low, so charge the batteries. The batteries may need maintenance. The battery could be defective or at the end of its life, so replace the batteries. The charger might be programmed incorrectly. A faulty charger can also cause this issue, so replace the battery charger.
J
john21Aug 7, 2025
What to do if Tennant Floor Machine does not propel?
- F
  fergusonmarkAug 7, 2025
  If the Tennant Floor Machine does not propel, the issue could stem from a propel fault. Ensure the operator is seated, as the machine requires this for operation. Check if the seat sensor wire harness plug is disconnected and connect it if necessary. Faulty propel motor or wiring could also be the cause.
A
Ashley MoralesAug 12, 2025
What to do if vacuum motor does not operate on Tennant Floor Machine?
- C
  Cindy VaughanAug 12, 2025
  If the vacuum motor on your Tennant Floor Machine isn't working, it might be due to a vacuum motor fault. Alternatively, there could be a faulty vacuum motor or wiring. Check if the circuit breaker tripped on the vacuum and reset the circuit breaker button.
M
Maxwell SmithAug 16, 2025
What to do if pad motor does not operate in Tennant Floor Machine?
- T
  tracy08Aug 16, 2025
  If the pad motor isn't working on your Tennant Floor Machine, the low voltage interrupter might be activated, so recharge the batteries. It could also be due to a pad motor fault.
K
Kyle WallaceAug 20, 2025
What to do if Tennant Floor Machine battery charger will not operate?
- M
  Morgan MaxwellAug 21, 2025
  If the battery charger won't operate, the charger fuse may be blown, so replace the charger fuse. The charger may also be faulty, so replace the charger.
H
Holly CooperAug 26, 2025
What to do if burnishing head will not lower or raise on Tennant Floor Machine?
- H
  Heidi Ball MDAug 26, 2025
  If the burnishing head won't lower or raise on your Tennant Floor Machine, make sure the 1--STEP button is pressed. The low voltage interrupter may be activated, so recharge the batteries.