What to do if my Tennant Floor Machine has no power?
If your Tennant Floor Machine has no power, check these potential causes: * Ensure the emergency stop button is not activated by turning the button to reset it. * Recharge the batteries if they are discharged. * Secure any loose or disconnected battery cable connections. * Reset the circuit breaker if it has tripped.
Why does my Tennant B5 have a short run time?
If your Tennant Floor Machine has a short run time, consider the following: * Charge the batteries if they have a low charge. * Replace batteries if they are defective or at the end of their life. * Decrease pad pressure if it is too high. * Replace the battery charger if it's faulty.
Why is my Tennant B5 vibrating?
If your Tennant Floor Machine is vibrating, consider these possible causes: * Remove and reinstall the pad to ensure it is properly centered. * Change to the proper pad if the current one is not suitable for the application. * Replace the pad if it is unevenly worn, soiled, or inspect and replace worn head lift bracket bushings.
Why is my Tennant B5 Floor Machine's burnishing performance poor?
If your Tennant Floor Machine has poor burnishing performance: * Flip or replace the pad if it is worn. * Adjust the pad pressure if it is incorrect.
What to do if the battery charger will not operate on my Tennant Floor Machine?
If the battery charger on your Tennant Floor Machine will not operate: * Replace the batteries if they are over discharged. * Replace the charger if it is faulty.
Provides critical safety warnings and precautions for operating the machine.
Guides on installing batteries, including specifications and warnings.
General| Model | B5 |
|---|---|
| Type | Walk-Behind Scrubber |
| Power Source | Battery |
| Brush Speed | 230 RPM |
| Battery Voltage | 24 V |
| Machine Type | Auto Scrubber |
| Cleaning Path Width | 20 in / 500 mm |
| Sound Level | 68 dBA |
To Next Page
