Tennant B7 - User Manual

Other manuals for Tennant B7

Service Information Manual64 pages

Questions and Answers

B
Benjamin MyersAug 8, 2025
What to do if my Tennant B7 has no power?
- T
  Tracy MooreAug 8, 2025
  If your Tennant Floor Machine has no power, check these potential causes: * Ensure the emergency stop button is not activated by turning the button to reset it. * Recharge the batteries if they are discharged. * Secure any loose or disconnected battery cable connections. * Reset the circuit breaker if it has tripped.
N
nicholelucasAug 13, 2025
Why does my Tennant B7 have a short run time?
- C
  Christopher BrownAug 13, 2025
  If your Tennant Floor Machine has a short run time, consider the following: * Charge the batteries if they have a low charge. * Replace batteries if they are defective or at the end of their life. * Decrease pad pressure if it is too high. * Replace the battery charger if it's faulty.
D
danielrobertsonAug 20, 2025
Why is my Tennant B7 vibrating?
- J
  John LangAug 20, 2025
  If your Tennant Floor Machine is vibrating, consider these possible causes: * Remove and reinstall the pad to ensure it is properly centered. * Change to the proper pad if the current one is not suitable for the application. * Replace the pad if it is unevenly worn, soiled, or inspect and replace worn head lift bracket bushings.
E
ecurryAug 26, 2025
Why is my Tennant B7 Floor Machine's burnishing performance poor?
- A
  Alan EspinozaAug 26, 2025
  If your Tennant Floor Machine has poor burnishing performance: * Flip or replace the pad if it is worn. * Adjust the pad pressure if it is incorrect.
B
brandonmorrisAug 31, 2025
What to do if the battery charger will not operate on my Tennant B7?
- E
  Elizabeth RodriguezAug 31, 2025
  If the battery charger on your Tennant Floor Machine will not operate: * Replace the batteries if they are over discharged. * Replace the charger if it is faulty.