Tenways CGO009 - Page 15

e
f
g
No.5 Hex Key
Note:
This step is very important. Please
follow the instructions carefully. Keep
the protective brake sheets for future use.
05
If yes, please follow the steps below to
make adjustments:
1. Use the No.5 Hex Key to slightly loosen
the mounting screws of the brake
clamps to make sure that they can
move slightly.
2. Press the front brake for 3 to 5
times.
3. Hold the front brake and tighten
the
mounting screws of the
brake clamps.
4. Turn the front wheel by hand
and listen for the sound of
friction.
5. If there is f riction, loosen
the brake clamps’ mounting
screws.
6. Manually adjust the brake
clamps’ positioning to center
of the disc, and then retighten
the screws.
Tools needed: No.15 Wrench and No.5 Hex Key
Install the front wheel 012