Tenways CGO009 - Front Mudguard

Front View
Side View
2
3
c
b
1
a
Tools needed: No.3 Hex Key, No.4 Hex Key,
and No.5 Hex Key
01
Use the No.5 Hex Key to loosen the screw
at the rear end of the front fork. Insert
the
mudguard from behind through the
front fork. Adjust the gap between the
mudguard and the tire, and tighten the
screws torque: 8
 14 Nm.
02
Use the No.4 Hex Key to loosen the screws
on both sides of the front fork and fasten
the mudguard support to the front fork
torque: 2
 4 Nm.
03
Use the No.3 Hex Key to loosen the screw
behind the front fork. Adjust the mudguard
height to make sure the mudguard does
not interfere with the wheel during riding.
Tighten the regulating screws torque:
24 Nm.
Tools needed: No.15 Wrench
01
Separate the left and right pedals, which
are marked by an R and an L respectively.
The right pedal is used for the side with
the crankset, while the left one is used
for the other side.
02
Tighten the right pedal clockwise and
the left pedal counterclockwise.
03
Please stop tightening the pedals if you
feel a lot of resistance. If this happens,
realign and reinstall the pedals.
Note:
Do not force the installation if you
feel a lot of resistance.
013 Install the front mudguard
04.
INSTALL THE
FRONT MUDGUARD
FUNCTIONS
AND BUTTONS