15
Step 4
Turn the front wheel by hand and check if there are any signs of scraping.
Step 5
If yes, please follow the steps below to make adjustments:
1. Use the 5 mm Hex Key to slightly loosen the mounting screws of the brake clamps to
make sure that they can move slightly.
2. Press the front brake 3 to 5 times.
3. Hold the front brake and tighten the mounting screws of the brake clamps.
4. Turn the front wheel by hand and listen for the sound of friction.
5. If there is friction, loosen the mounting screws of the brake clamps.
6. Manually adjust the position of the brake clamps to center the disc, and then re-
tighten the screws.
Attention
As the above steps are very important, please kindly follow them carefully.
5 mm Hex Key
Note
The protective sheet
on the brakes should
be kept for future use.
To Next Page
Loading...
