Terex Genie S-40 User Manual

Explains hazard symbols, color coding, signal words, and their meanings for safety communication.

Details the machine's purpose and guidelines for maintaining safety signs.

Defines various symbols and pictorials used to indicate hazards and safety instructions in the manual.

Outlines general safety principles and identifies the locations of safety signs on the machine.

Details personal safety requirements, focusing on fall protection equipment and its use.

Covers hazards related to electrocution, tip-over, and slope operation.

Details hazards related to collision, bodily injury, and other risks in the work area.

Addresses hazards associated with fire, explosion, batteries, and damaged or component damage.

Provides safety guidelines for welders, pipe cradles, and lockout procedures.

Describes the layout and functions of controls located on the machine's platform.

Details the layout and functions of controls found on the ground control station.

Explains the process and importance of conducting a thorough pre-operation inspection before using the machine.

Provides step-by-step instructions for testing all machine functions, steering, and braking systems.

Outlines the procedure for inspecting the work area to identify and avoid potential hazards.

Guides the user on how to verify that all safety and instructional decals are present and legible.

Details the procedure for starting the engine and the function of the emergency stop system.

Explains how to operate the machine from the platform, including steering and driving.

Provides guidance on operating the machine safely on various slopes, including grade determination.

Covers drive enable, speed selection, engine idle, and generator operation.

Instructs on the safe installation and use of pipe cradles and platform overload indicators.

Explains engine and level indicator lights and outlines procedures after each use.

Describes how to configure the machine for winching by disengaging the drive wheels.

Provides instructions on how to properly secure the machine to a transport vehicle for safe transit.

Details the correct procedures and lifting points for safely lifting the machine with a crane.

Explains how to check and maintain the proper engine oil level for optimal performance and longevity.

Covers procedures for checking and maintaining hydraulic oil and engine coolant levels.

Outlines the steps for checking battery condition, connections, and fluid levels for safe operation.

Specifies that quarterly, annual, and biennial maintenance must be performed by qualified technicians.

Lists the technical specifications for the Genie S-40 model.

Provides technical specifications and range of motion charts for the Genie S-45 model.