Operation 4
41/112TL160
Operating Manual 12.9.08 Version 1.0
4.3.2 Monitoring the machine during operation
• If the battery charge indicator (11/22) or the engine
oil pressure indicator lamp (11/31) lights up, switch
off the engine immediately and determine the
cause. If necessary, call for service personnel.
• If the permitted coolant temperature (11/25) is
exceeded, stop work, open the engine hood and
keep the engine running at idle speed to allow it to
cool down.
• Once the engine has cooled down, turn it off and
determine the cause of overheating. If necessary,
call for service personnel.
• If the air filter service indicator lamp (11/32) lights
up, perform the necessary air filter maintenance.
4.3.3 Switching off the engine
• Turn the ignition key to "0".
• The engine stops automatically.
Engine damage
due to fault which has not been remedied.
• The fault must be remedied before
restarting the engine and operating the
machine again.
Fig. 11 Monitoring and switching off the engine
00014,0 h
12 Km/h
0
4/4
1/2
+
-
P
25
22
31
32
Attention
Do not switch off the engine when running at
full throttle, but allow it to run for a short time
without load at low idle-running speed.
To Next Page
Loading...
