18
STOPPING OF ENGINE
Allow the diesel engine to slow down to the idling
speed and turn the ignition switch to the position
‘OFF’.
CAUTION! Don’t stop the engine when it is run-
ning at high speed and is warm.
When you leave the machine
Turn off the main switch and take the ignition switch with
you when leaving the machine. In this way you make certain
that all the electrical loads are disconnected and that unaut-
horized persons cannot start the machine.
DRIVING
Driving
N.B. Check that the load cylinder’s lever is in the
upper position, ‘free position’. The gearbox used
in Terri is of preselector type with two speeds. This
means that gear changes can only be made when
Terri is at a standstill.
•Release the brakes
•Move the load cylinder lever to the ‘free position’
•Engage the gears (low/high)
•Select the driving direction with the drive lever
•Increase the engine speed with the accelerator
pedal
Stopping of machine
The machine stops when the accelerator pedal
returns to the idling position or the drive lever is
moved to the mid-position. When the drive lever is
in the mid-position, the hydraulic circuit is closed
and the tracks do not rotate. (See the text about the
brakes.)
To Next Page
Loading...