Terri 2040 - Page 20

20
Checking of oil level
Check the oil level daily. The oil level shall lie
between the marks on the dipstick (4). Top up if
necessary. See page 34 regarding oil grades.
Changing of engine oil
Change the engine oil after every 100 hours of
service.
Run the engine so that it becomes warm.
Slacken the bolts (1) of the undershield by the
bumper, take out the bolt (2) in the middle and
lower down the undershield and withdraw it.
Place a suitable container between the tracks.
Open the drain plug through the hole in the bot-
tom and let the oilrun out.
Replace the drain plug and ll new oil through the
oil lling opening (3). See page 34 regarding the
amount of oil needed.
Check the oil level with the dipstick (4).
Replace the undershield.
Changing of oil lter
Change the oil lter (5) after every 200 hours of
service. Unscrew the old lter, smear the washer
of the new lter with engine oil and tighten the
lter by hand.