• Recent Clips - The footage in Recent Clips
continuously loops in 60-minute cycles
whenever the cameras are activate.
Therefore, footage is constantly
overwritten every hour unless you save it.
When an event is recorded, one video is
recorded for each of the front, rear, left,
and right cameras.
• Saved Clips - Contains all recordings that
you have manually saved using Dashcam
on page 78.
• Sentry Clips - Contains all footage from
Sentry Mode events which have been
automatically saved when an Alert or
Alarm state is triggered. The last 10
minutes of an event's footage is saved and
labeled with a unique timestamp.
Note: As the USB flash drive runs out of
available space, the oldest footage in
Sentry Clips is deleted to make room for
new footage. Once deleted, you will be
unable to retrieve them. When the flash
drive is full, Sentry Mode and Dashcam
can no longer save video footage. To
prevent the flash drive from getting full,
you must regularly move saved videos to
another device, and delete them from the
flash drive.
Note: You are responsible for complying with
all local laws, regulations, and property
restrictions regarding video recordings.
Note: The cameras do not record audio.
Save Clips on Honk
Once a properly formatted USB flash drive is
inserted in one of the vehicle's front USB
ports, you can choose to save dashcam clips
while driving when you honk the horn on your
steering wheel. Navigate to Controls > Safety
and Security > Save Clips on Honk > ON to
enable. The most recent ten minutes of
footage is saved. You can also save dashcam
footage by touching the dashcam icon at the
top of the touchscreen.
Security Settings
Using the Touchscreen 145
To Next Page
Loading...
Need help?
General
