TESTO 435 Series - Measuring Program (435-2;-4 Only)

6. Setting the instrument 51
Protocol
Saved measurement protocols can be printed out on a Testo printer (accessory
part) via the infrared interface.
²
Printing aa mmeasurement pprotocol:
 The main menu is open, Menu is displayed.
1 Memory ¬¬Protocol ¬ .
2 Press / to select the measurement protocol that is to be printed.
3 Press to start printing out the measurement protocol.
Delete
The entire memory with all measurement protocols can be cleared.
²
Clearing tthe mmemory:
 The main menu is open, Menu is displayed.
1 Memory ¬¬Delete ¬ .
2 Press to clear the entire memory.
6.2.2 Measuring program (435-2/-4 only)
A measuring program can be programmed and activated/deactivated:
Designation Description
Off Measuring program switched off: Readings can be stored manually
AUTO Automatic measuring program: The measuring cycle (min. 1s) and the number of
readings can be set freely.
Turb Automatic measuring program for measuring turbulence (only if a turbulence probe
is available and plugged in): The measuring cycle (1/5s) and duration (180s) are
preset.
²
Deactivating aa mmeasuring pprogram:
 The main menu is open, Menu is displayed.
1 Meas.Prog ¬ .
2 Press / to select Off and confirm with .
- The instrument returns to measurement view.
OK
OK
OK
OKOK
OKOK
de
en
fresitptsvnl????