Shenzhen TestPad Electronic Co., Ltd. http://www.test-pad.com
14
Setting lower threshold of impedance of R2
Setting upper threshold of impedance of R2
Selecting whether to test ID and the kind of ID
Selecting the type of ID
Setting whether to enable short-circuit test
Setting the maximum duration of short-circuit
protection Setting restoration mode after
short-circuit protection
Charge: Charge restoration
OPEN: Open-circuit restoration
Setting the time of open-circuit restoration
Setting maximum value of load voltage drop
Setting menu exit mode
Save: Saving current setting
No Save: Not saving current setting
Reset: Restoring default status
->17. R2-Min: 8.0 KΩ
18. R2-Max: 50.0 KΩ
19. CHECK ID MOTO
20. ID Type x2936
-> 21. Short TEST: YES
22. Short TIME: 25mS
23. Short Re: Charge
24. OPEN time: 100mS
-> 25. detV_Max: 0.20V
26. Exit Mode: Save
To Next Page
Loading...